LusoRobótica - Robótica em Português
Sistemas específicos => Arduino / AVR => Tópico iniciado por: mauricio em 07 de Novembro de 2008, 12:27
-
Olá a todos,
dos inventores da RepRap uma impressora 3D - http://www.reprap.org (http://www.reprap.org)
Um Arduino com + I/O's, com + memória Flash e muito mais...
Só ñ tem o Serial/USB converter Onboard, mas isso é fácil de resolver!
Similarities
* They both use ATmega family chips, and are very similar in architecture. Knowledge gained from programming an Arduino is directly applicable to programming a Sanguino.
* They both are intended to be programmed directly from the Arduino environment, so your sketches for Arduino will work with the Sanguino with minimal modifications.
* They are both open source and 100% hackable.
* They both use a bootloader for uploading sketches via serial.
Differences
The primary difference between the Arduino and the Sanguino is the processor: Arduino uses the atmega168, while the Sanguino uses the atmega644. The rest of the differences basically all derive from this.
Here is a table with a comparison between the boards:
(https://lusorobotica.com/proxy.php?request=http%3A%2F%2Fwww.dvpt.com%2Ftabela.gif&hash=1141fa175c3e9218f211bde12b7115cc03f8567a)
TODA A INFORMAÇÂO SOBRE O SANGUINO AQUI : http://sanguino.cc/start (http://sanguino.cc/start)
Este é o meu 1º Post e espero que seja útil !
Cumprimentos,
Mauricio Martins
-
Bem-vindo Mauricio Martins, e obrigado pelo post, existem realmente várias variantes do Arduino, e este parece ser um bom concorrente. Vou procurar saber mais.
(movido para a secção AVR)